Note: Some vehicles may require the ignition to be turned on or the vehicle running to program the HomeLink^® transceiver. To program a rolling code compatible HomeLink^® system, please follow these steps.

If you have a newer garage door opener from Overhead Door^® garage opener, including a Destiny^®, Odyssey^®, or Legacy^® 850 and the first 5 digits of the serial numbe​rs are 11291 or greater please find our HomeLink^®​ Programming instructions for these newer garage door opener models​.

For any serial number smaller than 11291, the following programming instructions are what you will need.

1. Press and hold the two outside buttons on the HomeLink^® system until the LED starts to blink, release buttons.
2. Press and hold the desired HomeLink^® button and the transmit button on your rolling code transmitter at the same time until the HomeLink^® LED changes from a slow blink to a rapid blink. (Your system is now programmed)
3. Locate the learn code button on your garage door opener. (These are located under the light cover or on the rear panel depending on the model)
4. Press the learn code button on the garage door opener, and a red LED will start to blink. (You will have 30 seconds to complete programming)
5. While the LED on the garage door opener is blinking, return to the vehicle and press the pre-programmed HomeLink^® button 4 times. (Or until the garage door operates).

HomeLink^® is a registered trademark of Gentex Corporation. For system problems call 1-800-355-3515 or visit their website.